Audiolab DC Block Mains Conditioner
Delivering ‘clean’ power to your amp, the Audiolab DC Blocker reduces transformer noise, letting you hear more of the music and less of the electronics.
DIRECT CURRENT BLOCKER – BANISH THE HUM
DC (Direct Current) signals within the mains current may be small but can noticeably affect sound quality. As the DC current enters a toroidal power transfer it becomes saturated, reducing the transformer’s efficiency and causing audible vibration. Connecting the DC Blocker reduces the mechanical hum and restores the mechanical efficiency – letting you concentrate on the music and not the background noise.
MAINS CONDITIONER AND RF FILTER
As well as DC removal, the DC Block also provides additional mains conditioning and RF filtering. These help reduce background noise further still, as noise from other components on the mains system (such as a fridge or dimmer switch switching on and off) is effectively filtered out.
IMPROVES THE ENTIRE SYSTEM
With a quieter mains signal being feed to your amplifier, the whole system benefits. A quieter amp means less distortion relayed to other components, helping reduce distortion and enhance music dynamics.
EASY TO CONNECT
No special installation or even additional mains sockets are required to fit the DC Blocker to your system. Simply plug into your amp’s IEC power socket and then connect to the mains socket vacated by the amp’s power cable.
STYLED TO MATCH YOUR SYSTEM
With its clean, crisp lines, the DC Block looks every bit as sleek as you’d expect from the Audiolab brand. Available in black or silver, the DC Block perfectly matches Audiolab’s other products and also blends well with components from other brands.
Hear the music you’ve been missing, with the Audiolab DC Blocker.
Direct Current Blocker
The typical mains supply is subject to various kinds of interference and non-linear loads, which distorts the AC waveform. Asymmetrical loads will cause the waveform to be offset and result in what is known as 'DC on the mains'. The amount of DC is only small, typically less than 500mV, but it only takes a small amount of DC to saturate a modern high flux toroidal transformer. Saturation of the transformer will invariably result in reduced efficiency and mechanical vibration.
Removing the DC from your mains supply will not only restore efficiency and reduce mechanical hum of noisy transformers, it will also improve the performance of the connected audio equipment, resulting in greater clarity and dynamics.
The audiolab DC BLOCK utilises a simple connection and intelligent design that will help remove DC from your mains power supply, instantly.
As well as DC removal, the audiolab DC BLOCK provides additional mains conditioning and RF filtering, of both common and differential mode noise, which further contributes to the optimal operation of your audio equipment.
The audiolab DC BLOCK mains conditioner is compatible with most audio equipment that utilises an IEC mains inlet and will offer a no-nonsense, instant improvement to the mains power supply, and ultimately, the performance of your Hi-Fi system.
Key Features:
- Removes DC from AC mains supply
- Reduces transformer hum
- Reduces RF interference
- Improves the performance of audio components
Post a Comment